Dolphin 1933 Portsmouth exterior photos

Notes

After the completion of the 1932 Post-Shakedown Availability, Dolphin made a voyage to San Diego between October and December of 1932. She remained there for three months, operating with elements of the Pacific Fleet. She made the long transit back to Portsmouth in March 1933 where she went into a second and final PSA. Several significant changes were made during this yard period which lasted until August, 1933. These exterior changes are outlined below in a series of 14 photographs, all taken on July 5 and 7, 1933.

The Dolphin fore deck as viewed from the bridge. The location is just outside the dry dock at Portsmouth Naval Shipyard. Picture was taken July 5, 1933.

The heavy dual cables on either side of the photo were a combination of medium range radio aerial and mine clearance cable. The lower cable was the aerial and it can be seen connecting to a pressure-proof fitting right at the forward edge of the bridge fairwater.

This heavy cable was supported on the forward and after decks by tri-pod masts and in the center by rectangular stanchions on either side of the bridge fairwater. At the very top of the picture can be seen the much thinner long-range aerial which is supported in the center by the extendable radio mast.

In the lower center of the photo is a mushroom-shaped ventilation valve. It closed off a ventilation intake that serviced the forward half of the boat.

Seen in the lower left of the photo is the under deck storage for one of the ship's launches. To launch the boat the deck covering would be removed, and the boat hoisted out and placed in the water by the torpedo loading derrick. On deck a dungaree-clad Chief Petty Officer can be seen talking with another person, probably a civilian yard worker. Though Chiefs had dress uniforms they had no working uniforms (Khaki) at this time and just wore dungarees the same as lower rates, just adding their round top combination hat.

US Navy Photo Contributed by Roger Torgeson

The forward rescue marker buoy looking aft. This is a feature installed on all boats in the aftermath of the S-4 disaster and would later prove to be a key factor in the successful rescue of 33 men from the sunken USS Squalus. This buoy could be released from the inside and would mark the boat's location to rescue forces in the event of an accident.

Seen at the top of the photo and just to the right of the tri-pod leg you can see the outline for the under-deck boat storage.

US Navy Photo Contributed by Roger Torgeson

Forward messenger buoy in its housing on the main deck. The sign says: "Submarine Sunk Here Telephone Inside" and the cover plate is opened by unscrewing the wingnuts to reach the telephone. Rescue forces could then speak to the trapped men below.

US Navy Photo Contributed by Roger Torgeson

View topside looking aft from the "cigarette deck" aft of the bridge. This view highlights one of the major alterations made to Dolphin during this yard period. The housing on the aft deck that had contained the second small boat was greatly extended to cover three non-firing torpedo storage tubes (see below). This gave Dolphin a distinctive hump on the aft deck. Further aft can be seen the side-by-side humps covering the main engine mufflers, and the aft escape trunk in the center.

US Navy Photo Contributed by Roger Torgeson

View looking forward from the newly expanded "Cigarette Deck" (so named as it was a great spot to catch a smoke while underway) towards the bridge.

Directly underneath the photographer's feet would be the large, man-sized mushroom shaped main air induction valve, used to draw air into the engine rooms for the diesel engines.

The telescoping radio aerial mast can be seen in the foreground, and in the background is the covered weather bridge. On either side of the periscopes are two fold-up stands used by the lookouts.

The hatch in the deck seen on the left leads up from a void space aft of the conning tower. That space is just outside the deck access door located at the aft end of the conning tower (see interior conning tower photos).

US Navy Photo Contributed by Roger Torgeson

The Dolphin's enclosed bridge, sometimes known as a weather bridge, a navigation bridge, or a pilothouse. It was used by the Officer of the Deck, helmsman, and lookout(s) while the boat is surfaced.

This is a free flooding area and many of the items located here were made of brass. In the center is the large helm wheel, connected mechanically to a similar unit in the conning tower and control room below.

Next to the wheel is the ship's magnetic compass binnacle, with two arms on each side supporting compensating spheres that zeroed out the effect on the compass of the steel hull. in front of the binnacle is a ventilation pipe.

On the far left and far right are the engine order telegraphs that were used to transmit speed orders for each shaft to the maneuvering room back aft. To the left of the binnacle are rudder angle indicators.

On the right of the binnacle is a curved pipe with a valve. This is the speaking tube down to the conning tower used to send voice commands to the personnel stationed below. The cone sitting on the deck attaches to the valve and concentrates the voice similar to a megaphone. Above the binnacle is a handle that when pulled down actuated the ship's air whistle. The whistle can also be actuated by the two levers attached to the aft end of the enclosure at the top.

The large, heavy tub on the top of the enclosure houses a compass with a 'pelorus', a rotating ring with folding 'peep sights' allowing bearings of objects used in targeting and or navigation relative to the submarine. It is watertight and pressure proof and is opened by turning the handle on the right.

US Navy Photo Contributed by Roger Torgeson

Conning tower fairwater and amidships superstructure. The conning tower itself is a separate pressure proof hull mounted to the top of the main pressure hull and enclosed by this section of the superstructure and the fairwater, which is all free flooding when submerged.

On the forward end of the fairwater can be seen the ship's bell, and two horns for the air whistle. The thick medium range radio aerial wire can be clearly seen here, and the thinner long range aerial is seen supported by the extended mast.

The "D1" on the fairwater is called a class identifier and is used to provide long range visual ID of the boat while it is surfaced, D1 meaning the first boat of the D-Class (as it turned out there was only one boat in this class). Once large numbers of fleet boats began entering surface the use of class identifiers became unwieldy and they were replaced with the boat's hull number in the fall of 1938.

The vertical opening just forward of the D1 is the boat's starboard running light. Directly above the "1" can be seen the upper end of one of the boat's periscopes, and above that is a fork shaped bracket for a search/signal light.

Just forward of the civilian in the sport coat and white hat is a doorless oval opening leading into the interior of the fairwater. This allows crewmen access to the main deck after exiting the conning tower through a watertight door in its aft end.

There are two doored accesses in the fairwater forward (near the two workers), one on the port side and one on the starboard, with the port door being open. The two workers are readying the newly installed accommodation ladder for opening (see photos below).

Note telephone cable running from bridge to the dock to allow submarine to shore communications while in port. The shore phone usually sat in the control room or in the conning tower.

US Navy Photo Contributed by Roger Torgeson

This is a good view of the boat's 4"/50 caliber Mk 9 deck gun. This was a rugged and well-liked weapon that was a good compromise between ease of use and hitting power.

Its bore was made watertight by a removable tampion in the muzzle end and a Smith-Asbury type side swing breech. Even with being watertight the weapon required constant and detailed maintenance or the repeated dunkings in salt water would quickly render it unusable due to corrosion.

US Navy Photo Contributed by Roger Torgeson

A closer view of the conning tower fairwater. The three round circles are artifacts of the developing process.

US Navy Photo Contributed by Roger Torgeson

The accommodation ladder added after the subs return from her 5500 mile Oct 1932 to March 1933 trial trip to the west coast. Photos from 1932 do not show these steps. There is an identical set on the port side of the deck.

This close up view of the opened accommodation ladder, allowing easy access to the main deck from a small boat alongside. In the 1930's submarines frequently anchored out while in port, or moored to an anchored tender, necessitating the use of the ship's liberty launches to ferry the crew ashore. Just to the left of the ladder the curved hull of the conning tower can barely be seen, inside the superstructure.

US Navy Photo Contributed by Roger Torgeson

Non-firing torpedo storage tubes at the aft end of the raised deck. These tubes were not part of the original design and were added in the 1933 overhaul. The idea of deck stored torpedoes and external torpedo tubes was revived during WW II though these proved not popular with skippers. By the end of the war most of these had been removed.

Since the internal torpedo capacity was reduced from 21 to 18 these tubes augmented what was carried below in the two torpedo rooms. The weapons would be pulled out of these tubes and moved below via circular deck hatches in each torpedo rooms. The deck alongside the fairwater was wide enough to allow the torpedoes to be moved forward if necessary. This must have been a harrowing experience in any kind of seaway moving a one-ton torpedo around the moving decks. Most likely they used some sort of wheeled cart that was stored below deck.

The open hatch is located at the forward end of the Engine Room. The Generator Room was directly below the raised deck area.

US Navy Photo Contributed by Roger Torgeson

After escape trunk and torpedo loading hatch. The flared top of the trunk is designed to allow a McCann Rescue Chamber to mate to it and provide a watertight seal. This allowed trapped crewmen to exit the boat directly to the rescue chamber via the top hatch.

If the rescue chamber was not available or could not be used the crew would make an escape using Momsen Lungs. In this case the top hatch would remain shut and after entering the trunk and shutting the lower hatch the crewmen would flood the trunk to the level of the top of the side door.

This left a small air bubble at the top of the trunk. They would then open the side door, push themselves out, and float to the surface using the Momsen Lung to breathe on the way up. Crewmen inside the boat would then shut the door via a hydraulically operated arm, drain the trunk, then set it up for another use.

The circular hatch in the back of the trunk is the torpedo loading hatch. With this hatch and the side door open torpedoes were carefully winched down on an angle into the after torpedo room. There is a similar trunk on the forward deck leading into the forward torpedo room, but this trunk is less apparent visually because the depth of the superstructure forward allows the top hatch to be flush with the walking deck.

US Navy Photo Contributed by Roger Torgeson

Dolphin leaving for a trial run. The date is July 7, 1933. She is seen here traveling down the Piscataqua River off Portsmouth, with Kittery, ME in the background.

US Navy Photo Contributed by Roger Torgeson

Return to Dolphin main page | Return to V-class main page

Page created by:
Ric Hedman & David Johnston
1999 - 2023 - PigBoats.COM^©
Mountlake Terrace, WA, Norfolk, VA
webmaster at pigboats dot com