Torpedo photos & information

From PigBoats.COM
Revision as of 21:12, 16 August 2024 by Pbcjohnston (talk | contribs) (Work on formatting)

Whitehead Mk 2 & Mk 3

The Whitehead Mk 2 and Mk 3 weapons were actually a surface ship design adapted later for submarine use. They were powered by a three-cylinder radial engine run on compressed air. They were so similar in configuration that it was hard to tell them apart. Indeed, they had the exact same operational parameters. However, the big difference is that the Mk3 was the first USN torpedo to use a gyroscope for azimuth control. This reduced deviation from left or right of planned track from 24 yards to just 8 yards. That is still a big margin, but in those early days it was quite impressive accuracy.


Whitehead Mk 3 torpedoes stored at the weapons depot at Naval Station Cavite, Philippines, approximately 1906. The wheeled carts allowed the quick movement of the weapons from storage to the pier.

Photo in the private collection of Ric Hedman.

Navy photos of a Mk 3 weapon being loaded into the USS A-2 (Submarine No. 3) at Naval Station Cavite, Philippines, circa 1912. The sailor manhandling the weapon down the hatch gives a good sense of scale to the torpedo, and illustrates how short the mid-body was compared to later torpedoes. Our early submarines were restricted to the use of these short weapons because they were the only ones that would fit inside the boats and the tubes they used. That would quickly change.

Bliss-Leavitt Mk 4 Mod 1

The Bliss-Leavitt Mk 4 was the first torpedo specifically designed for submarine use. The surface navy had begun the transition to larger 21" diameter torps, but they would not fit in the restricted spaces of the submarines of the time, thus the BL Mk 3 was scaled down to 17.7" for submarine use. The propulsion system was vastly different from the earlier Whitehead weapons in that the Mk 4 used a vertical turbine spun by air heated by an alcohol burner. This greatly increased the pressure of the air and when combined with the turbine it increased the speed and range of the weapon.


D-3 hoisting aboard a Mk 4 torpedo that it as just recovered from a practice shot, circa 1912. This photo gives a good view of the aft end of the weapon, including the control surfaces and the twin contra-rotating propellers. The twin propellers spinning in opposite directions eliminated roll torque, preventing the weapon from cork-screwing along its longitudinal axis. Eliminating the roll torque also allowed the gyro to maintain a more accurate course.

Another view of the operation shown above. There is a snubbing line attached to the aft end of the weapon, looped around the #1 periscope. This line allowed the weapon to be gently and carefully lowered into the torpedo room.

Bliss-Leavitt Mk 6

Bliss-Leavitt Mk 7

Bliss-Leavitt Mk 9 Mod 1B

Bliss-Leavitt/BuOrd Mk 10 Mod 3

BuOrd Mk 14

Westinghouse Mk 18 Mod 1

BuOrd Mk 23

Page created by:
Ric Hedman & David Johnston
1999 - 2023 - PigBoats.COM©
Mountlake Terrace, WA, Norfolk, VA
webmaster@pigboats.com